Learn More
Sling Tension: Angle Effects, WLL Reductions, and ASME B30.9 Requirements
How sling angle affects leg tension, ASME B30.9 choke angle WLL reductions, D/d ratio effects on wire rope, and safe rigging practices for multi-leg lifts.
Center of Gravity: Calculating CoG for Unbalanced and Composite Loads
How to calculate center of gravity for asymmetric loads, determine sling length ratios for level lifts, and predict tilt angles. Composite body method explained.
Spreader Bar & Lifting Beam: Sizing, Buckling, and Section Modulus
Preliminary sizing of spreader bars (compression) and lifting beams (bending). Euler buckling checks, section modulus requirements, and common tube properties.
Related Tools
Shop Heater BTU Sizing Calculator
Calculate the exact BTU output your shop or garage heater needs. Factors in wall R-values, ceiling insulation, slab edge loss, overhead door infiltration, and air changes per hour to size propane, natural gas, and electric heaters correctly.
Overhead Door Infiltration Loss Calculator
Calculate heat loss through overhead doors in shops, garages, and warehouses. Compares open-door vs closed-door losses, seal condition impact, and annual cost of infiltration with payback on door seals and high-speed doors.
Long-Run Voltage Drop Calculator
Calculate voltage drop for long wire runs to detached shops, barns, garages, and outbuildings. Compares copper vs aluminum, shows motor starting voltage impact, and recommends the right wire size for your distance and load.